[RTP Company]

Product Data Sheet &
General Processing Conditions


RTP PA6 L BLK
Nylon 6 (PA)
Value Product
Lubricated
Heat Stabilized



PROPERTIES & AVERAGE VALUES OF INJECTION MOLDED SPECIMENS

PERMANENCE
English SI Metric ASTM
TEST
 
Specific Gravity1.13 1.13  D 792
Molding Shrinkage 
    1/8 in (3.2 mm) section0.0100 - 0.0200 in/in 1.00 - 2.00 %  D 955

MECHANICAL
 
Impact Strength, Izod 
    notched 1/8 in (3.2 mm) section0.8 ft-lbs/in 43 J/m  D 256
    unnotched 1/8 in (3.2 mm) sectionNo Break No Break  D 4812
Tensile Strength9500 psi 66 MPa  D 638
Tensile Elongation> 10.0 % > 10.0 %  D 638
Tensile Modulus0.45 x 10^6 psi 3103 MPa  D 638
Flexural Strength14000 psi 97 MPa  D 790
Flexural Modulus0.40 x 10^6 psi 2758 MPa  D 790

THERMAL
 
Deflection Temperature 
    @ 264 psi (1820 kPa)160 °F 71 °C  D 648
Ignition Resistance* 
    Flammability**V-2 @ 1/32 in  V-2 @ 0.8 mm  D 3801
 
PROPERTY NOTES
 
Data herein is typical and not to be construed as specifications.
Unless otherwise specified, all data listed is for natural or black colored materials. Pigments can affect properties.
* This rating is not intended to reflect hazards of this or any other material under actual fire conditions.
** Values per RTP Company testing.

GENERAL PROCESSING FOR INJECTION MOLDING
 English SI Metric  
 
Injection Pressure10000 - 15000 psi 69 - 103 MPa  
Melt Temperature470 - 535 °F 243 - 279 °C  
Mold Temperature130 - 200 °F 54 - 93 °C  
Drying2 hrs @ 180 °F 2 hrs @ 82 °C  
Moisture Content0.20 % 0.20 %  
Dew Point0 °F -18 °C  

PROCESSING NOTES
 
Desiccant Type Dryer Required.

20 Feb 2006 NPB

This information is intended to be used only as a guideline for designers and processors of modified thermoplastics. Because design and processing is complex, a set solution will not solve all problems. Observation on a “trial and error” basis may be required to achieve desired results.

Data are obtained from specimens molded under carefully controlled conditions from representative samples of the compound described herein. Properties may be materially affected by molding techniques applied and by the size and shape of the item molded. No assurance can be implied that all molded articles will have the same properties as those listed.

No information supplied by RTP Company constitutes a warranty regarding product performance or use. Any information regarding performance or use is only offered as suggestion for investigation for use, based upon RTP Company or other customer experience. RTP Company makes no warranties, expressed or implied, concerning the suitability or fitness of any of its products for any particular purpose. It is the responsibility of the customer to determine that the product is safe, lawful and technically suitable for the intended use. The disclosure of information herein is not a license to operate under, or a recommendation to infringe any patents.

RTP COMPANY • 580 EAST FRONT STREET • WINONA, MN 55987 • 507-454-6900