[RTP Company]

Product Data Sheet &
General Processing Conditions


RTP 283
Nylon 6/6 (PA)
Carbon Fiber Reinforced


PROPERTIES & AVERAGE VALUES OF INJECTION MOLDED SPECIMENS

PERMANENCE
 STANDARD
 
Primary Additive20 %  
Density1.21 g/cm  ISO 1183
Shrinkage, 4 mm Thickness 
    Flow direction0.18 %  ASTM D 955

MECHANICAL
 
Impact Strength, Izod 
    Notched, 4 mm thickness5 kJ/m  ISO 180/1A
    Unnotched, 4 mm thickness39 kJ/m  ISO 180/1U
Tensile Strength195 MPa  ISO 527
Tensile Elongation2.0 - 3.0 %  ISO 527
Tensile Modulus14300 MPa  ISO 527
Flexural Strength280 MPa  ISO 178
Flexural Modulus11080 MPa  ISO 178

ELECTRICAL
 
Volume Resistivity< 1E3 ohm.cm  IEC 60093
Surface Resistivity< 1E5 ohm  IEC 60093

THERMAL
 
Heat Deflection Temperature 
    @ 1.80 MPa248 C  ISO 75
 
PROPERTY NOTES
 
Data herein is typical and not to be construed as specifications.
Unless otherwise specified, all data listed is for natural or black colored materials. Pigments can affect properties.

GENERAL PROCESSING FOR INJECTION MOLDING
 
Injection Pressure70 - 125 MPa  
Injection Pressure680 - 1240 bar  
Melt Temperature275 - 300 C  
Mold Temperature65 - 105 C  
Drying4 hrs @ 80 C  
Moisture Content0.20 %  
Dew Point-25 C  

PROCESSING NOTES
 
Desiccant Type Dryer Required.
 
15 Sep 2010 MAB

This information is intended to be used only as a guideline for designers and processors of modified thermoplastics. Because design and processing is complex, a set solution will not solve all problems. Observation on a “trial and error” basis may be required to achieve desired results.

Data are obtained from specimens molded under carefully controlled conditions from representative samples of the compound described herein. Properties may be materially affected by molding techniques applied and by the size and shape of the item molded. No assurance can be implied that all molded articles will have the same properties as those listed.

No information supplied by RTP Company constitutes a warranty regarding product performance or use. Any information regarding performance or use is only offered as suggestion for investigation for use, based upon RTP Company or other customer experience. RTP Company makes no warranties, expressed or implied, concerning the suitability or fitness of any of its products for any particular purpose. It is the responsibility of the customer to determine that the product is safe, lawful and technically suitable for the intended use. The disclosure of information herein is not a license to operate under, or a recommendation to infringe any patents.

RTP COMPANY • 580 EAST FRONT STREET • WINONA, MN 55987 • 507-454-6900