[RTP Company]

Product Data Sheet &
General Processing Conditions


RTP 4930-2320 UV
Thermoplastic Polyolefin (TPO)
Mineral
UV Stabilized
Preliminary Datasheet


PROPERTIES & AVERAGE VALUES OF INJECTION MOLDED SPECIMENS

PERMANENCE
 STANDARD
 
Primary Additive30 %  
Density1.13 g/cm³  ISO 1183
Melt Flow Rate 
    @ 230 °C, / 2.16 kg20.00 g/10 min  ISO 1133

MECHANICAL
 
Impact Strength, Izod 
    Notched, 4 mm thickness45 kJ/m²  ISO 180/1A
    Unnotched, 4 mm thicknessNo Break  ISO 180/1U
Tensile Strength17 MPa  ISO 527
Tensile Elongation> 10.0 %  ISO 527
Tensile Modulus2100 MPa  ISO 527
Flexural Strength26 MPa  ISO 178
Flexural Modulus2300 MPa  ISO 178
 
PROPERTY NOTES
 
Data herein is typical and not to be construed as specifications.
Unless otherwise specified, all data listed is for natural or black colored materials. Pigments can affect properties.

GENERAL PROCESSING FOR INJECTION MOLDING
 
Injection Pressure70 - 105 MPa  
Melt Temperature190 - 230 °C  
Mold Temperature30 - 65 °C  
Drying2 hrs @ 80 °C  

PROCESSING NOTES
 
 
4 Dec 2017 ZTH

This information is intended to be used only as a guideline for designers and processors of modified thermoplastics. Because design and processing is complex, a set solution will not solve all problems. Observation on a “trial and error” basis may be required to achieve desired results.

Data are obtained from specimens molded under carefully controlled conditions from representative samples of the compound described herein. Properties may be materially affected by molding techniques applied and by the size and shape of the item molded. No assurance can be implied that all molded articles will have the same properties as those listed.

No information supplied by RTP Company constitutes a warranty regarding product performance or use. Any information regarding performance or use is only offered as suggestion for investigation for use, based upon RTP Company or other customer experience. RTP Company makes no warranties, expressed or implied, concerning the suitability or fitness of any of its products for any particular purpose. It is the responsibility of the customer to determine that the product is safe, lawful and technically suitable for the intended use. The disclosure of information herein is not a license to operate under, or a recommendation to infringe any patents.

RTP COMPANY • 580 EAST FRONT STREET • WINONA, MN 55987 • 507-454-6900