[RTP Company]

Product Data Sheet &
General Processing Conditions


RTP 2800 B-85A HF UV
Thermoplastic Polyolefin Elastomer (TEO)
UV Stabilized



PROPERTIES & AVERAGE VALUES OF INJECTION MOLDED SPECIMENS

PERMANENCE
English SI Metric ASTM
TEST
 
Specific Gravity1.03 1.03  D 792
Melt Flow Rate 
    @ 204 °C, / 5 kg125.00 g/10 min 125.00 g/10 min  D 1238

MECHANICAL
 
Tensile Strength 
    Break, Die C, 0.125 in, 20 in/min (3.2mm, 500 mm/min)1310 psi 9 MPa  D 412
Tensile Elongation 
    Break, 20 in/min (500 mm/min)530.0 % 530.0 %  D 412
Tensile Stress 
    Die C 0.125 in, 20 in/min (3.2 mm, 500 mm/min) 
    @ 100 %795.0 psi 5.5 MPa  D 412
Tear Strength, Die C235.0 pli 41.2 N/mm  D 624
Hardness 
    Shore A, 10 s delay90 90  D 2240
 
PROPERTY NOTES
 
Data herein is typical and not to be construed as specifications.
Unless otherwise specified, all data listed is for natural or black colored materials. Pigments can affect properties.

GENERAL PROCESSING FOR INJECTION MOLDING
 English SI Metric  
 
Melt Temperature360 - 410 °F 182 - 210 °C  
Mold Temperature60 - 150 °F 16 - 66 °C  
Drying2 hrs @ 175 °F 2 hrs @ 79 °C  
Moisture Content0.03 % 0.03 %  
Dew Point0 °F -18 °C  

PROCESSING NOTES
 

13 May 2011 RLR

This information is intended to be used only as a guideline for designers and processors of modified thermoplastics. Because design and processing is complex, a set solution will not solve all problems. Observation on a “trial and error” basis may be required to achieve desired results.

Data are obtained from specimens molded under carefully controlled conditions from representative samples of the compound described herein. Properties may be materially affected by molding techniques applied and by the size and shape of the item molded. No assurance can be implied that all molded articles will have the same properties as those listed.

No information supplied by RTP Company constitutes a warranty regarding product performance or use. Any information regarding performance or use is only offered as suggestion for investigation for use, based upon RTP Company or other customer experience. RTP Company makes no warranties, expressed or implied, concerning the suitability or fitness of any of its products for any particular purpose. It is the responsibility of the customer to determine that the product is safe, lawful and technically suitable for the intended use. The disclosure of information herein is not a license to operate under, or a recommendation to infringe any patents.

RTP COMPANY • 580 EAST FRONT STREET • WINONA, MN 55987 • 507-454-6900